Wall Mount UV-Fluorescence Oil in Water
Monitor FPM 605
The product
brochure will be available for download soon!
Technical Data
- Method of operation: UV fluorescence detector
- Dimensions (W x D x H): 430 mm x 480 mm x 270 mm
- Weight approx.: 18 kg (40 lb.)
- Detection range: 1ppm - 1000 ppm (detection limits depend
on target analyte and matrix)
- Plumbing requirements: Feed in: approx. 200 ml/min, 2"
unrestricted drain
- Response time: < 12 seconds, depending on actual flow
through sample cell
- Operating temperature: 5 - 45°C, for extreme temperature
conditions contact manufacturer
- Ambient temperature: 5-45°C (41-110°F)
- Sample temperature: Max 60°C
- Calibration: Multi point (min. 2 point)
- Zero drift: <2.0% FSD / 24h
- Span drift: <2.0% FSD / 24h
- Linearity: 1,5%
- Measuring ranges (ppm): 0-100 and 0-1.000, alt. 0-200 and
0-2000ppm
- Analog outputs: 0-10VDC and 4-20mA; RS 232 data out optional
- Display : 3 1/2-digit, red LED, 6-digit engineering display
optional
- Sample flow: approx. 250 cc/min through flow cell
- Zero and span adjust: Manual on front panel
- Routine maintenance: Lamp once every 20,000 hours, routine
cleaning of optics, flow cell and sample containing plumbing
- Air consumption for air curtain: approx. 1liter per minute
(built it air supply optional)
- Temperature control: Optional for cold weather conditions,
digital PID-type controller
- Power requirements: 115VAC/60Hz, 150 W, or 230VAC/50Hz
Available Options
- ENGA 65 6-digit engineering units display, 0-10.000 ppm with
RS 232 data output, no range change necessary over the span of
three 10VDC analog decades (between 0 to 1000ppm) Range changing
is only required when an analog strip chart recorder is used
- AMU 65 Automatic range change
- CIM 65 RS 232 data output, not necessary with ENGA 65
- EAP 65 Air purge kit to meet class I Division II (explosion
proofing)
- DBP 65 Water overflow sampling and de-bubbeling system. Accurate,
bubble free sample flow regulation due to height adjusted mounting
of the system besides the right side of the monitor next to sample
inlet
- PAS 65 External hydrocarbon free air supply with pump and
air purifier for air curtain
- RCA 65 0-20mA analog output instead of 4-20mA
- RCC 65 Remote control range change
- RCI0 65 0-20 mA analog output, galvanically isolated
- RCI4 65 4-20 mA analog output, galvanically isolated
Back
Clear Passage Products L.P reserves
the right, at any time and without notice, to change specifications
presented in this data sheet and assumes no responsibility for
the application or use of the products described herein.